Thank you for your help!
First, remove two screws from the reader.
By changing a net protector antivirus update 2012 latest jumper, this reader will be supported using generic Windows USB Mass Storage driver, so it'll be usable on any computer with Windows 2000 and.
Comments to this Manuals, latest comments: Bookmark m, upload manual upload from disk upload from url.Connect R28, 100 Ohm goes to R38 (if there isn't).You should see (from the corner upwards) a SMD resistor used as a jmper (code 000 a SMD pads for resistor and a capacitor.You can re-make front panel for all 5 LEDs, like mine: Another picture of everything inside: OK, if you're curious and you see that these resistors have the same color codes.I think you can remove this resistor by ripping it from the board, but it's not good for tracks, and they must remain good.On a board, near these cables, you will see a 5 LED places.Link SMD pads labelled as R43.MCbx 2010, sources: ND3060 Datasheet (it's hard to get this).LED3 - is fatal error during installation skype kernel32.dll a CF card indicator.Link R42, connect like LED4.And to connect an USB cable: Looking to front of the reader: Red - White - Green - Black (Power - -data - data - GND).Yes, they are about 60Ohm resistors cut down using a flat file to suit my needs.If there's no resistor in R26, there must be about 100 Ohm.Once reported, our staff will be notified and the comment will be reviewed.WhatsApp Messenger imo free video calls and chat.It is possible to tell the neodio not to use this chip, and let be directed by Windows driver instead.
It's ready for disassemble.